Kett Part-R-1 Heater assembly for FD-660

Kett Part-R-1 Heater assembly for FD-660

Heater Replacement

• Turn off the power, and unplug the power cord.
• Remove the heater lid.

Remove the screws on both sides of the heater lid after ensuring that the heater lid and heater are thoroughly cooled. Lift the heater lid diagonally forward while moving it forward, and remove the lid.

• Remove the heater.

Disconnect the coupling on the back side of the main unit. If it is hard to disconnect the coupling, open the rear cover slightly from side to side and try to disconnect it. Raise the bracket holding the wire of the heater, and disengage the wire. Remove the metal thumb nut that secures the heater holder base. Disengage the hook while moving the heater holder base backward, and lift it.

• Mount a new heater.
  Firmly secure the wire and holder base as to cross the wire.
  ** Plug the the connector on left side, if you are replacing the right heater.
  ** Plug the the connector on right side, if you are replacing the left heater.
  ** Do not touch the glass part of the new heater with your bare hands. If an oil spot or soil is attached to the glass surface, the heater may deteriorate, and its life may be shortened.
• Finally, attach the heater lid.